Are you looking for ways to reduce the heat build-up in your home and lower your cooling costs? Installing a radiant barrier along with your new attic insulation is a great way to do just that. Radiant barriers are highly reflective materials that reflect radiant heat instead of absorbing it, and they can be combined with many types of insulating materials in reflective insulation systems. In new buildings, there are several methods for installing radiant barriers. It's easier to incorporate them into a new home, but you can also install them in an existing home, especially if it has an open attic.
However, reflective insulation placed on walls or on the attic floor must be so. It is not recommended to place radiant barriers directly on the attic floor insulation, as this can lead to dust accumulation and trap moisture in the fiber insulation. When insulation is not installed in roof attics in summer, air conditioning systems tend to withstand more loads and consume more electricity, resulting in higher utility bills. Its isolation has small peaks and valleys that usually work perfectly to keep most of the sheet just above the insulation. If you want these insulations to be properly installed, you should hire an expert company, such as FrozenHVAC, for better and more efficient services. Yes, you can install the sheet directly on the existing roof in the attic since it can withstand light or moderate traffic.
However, take the time to read the warnings at the bottom of this page regarding the installation of aluminum sheets directly onto attic insulation in cold climates. Attic insulation is really effective at controlling the heat that comes from the sun. These attic insulations are great, but sometimes they are not enough to prevent heat from entering your house. For this reason, it is necessary to install a radiant barrier along with the attic insulation. Radiant barriers are installed in homes, usually in attics, mainly to reduce heat build-up in summer and reduce cooling costs. Although insulating materials, such as polystyrene and polyurethane, tend to be slightly less efficient over time, the age of the insulation is probably not the cause of the high costs (except in the case of houses built before 1940).
